Our company specializes in importing industrial control spare parts, and we can help you transfer most of them from abroad. Due to the wide variety of models, we were unable to upload physical pictures one by one!
If the model you need cannot be found in our store, please feel free to inquire at any time.
GE IC660BBD023｜Genius I/O｜
1、 Channel configuration
Quantity: 16 independent I/O channels, 16 points per group
Mode: Each channel software can choose input (Sink)/output (Source)/tri state input
Wiring: Source type, common terminal 24/48VDC+
2、 Digital input (when channel is set as input)
Rated voltage: 24/48VDC (18-56VDC wide voltage)
Input impedance: ≥ 10k Ω
Response time: 1.7ms (basic)+software filtering (5/10/20/50/100ms)
High level: ≥ 15VDC; Low level: ≤ 5VDC
Diagnosis: Open circuit, short circuit, overheating, and three state fault detection
3、 Digital output (when channel is set as output)
Output type: MOSFET source type, high side switch
Rated voltage: 24/48VDC (18-56VDC)
Each current: 2A (continuous), surge 10A/10ms
Total output current: 16A (16 channels at full load simultaneously)
On delay: ≤ 1ms; Off delay: ≤ 2ms
Pressure drop: ≤ 2.0V@2A
Leakage current: ≤ 1mA (off state)
Minimum load: 50mA (enable No Load function when no load)
Maximum switching frequency: 1Hz (in high wave scenarios)
4、 Electrical and Isolation
Working voltage: 18-56VDC (nominal 24/48VDC), ripple ≤ 10%
Isolation strength: 1500VAC/1 minute (between modules, channel to ground)
Power consumption: typical 150mA, maximum 300mA (24VDC)
Power off hold: 10ms (data not lost in case of power interruption)
5、 Environment and Physics
Working temperature: 0 ° C~+60 ° C
Storage temperature: -40 ° C~+85 ° C
Relative humidity: 5% -95% RH (without condensation)
Vibration: 5-10Hz: 5.08mm displacement; 10–200Hz：1G
Impact: 30g (11ms)
Size (mm): 224 × 90.5 × 112.3
Weight: Approximately 1.8 kg
Installation: 35mm DIN rail or panel installation
Protection: IP20 (to be installed inside a protective cabinet)
6、 Communication and Diagnosis
Bus protocol: Genius Bus (dedicated twisted pair)
Topology: daisy chain, up to 32 nodes, up to 2km away
Diagnostic LED: module OK, I/O enabled, each channel status indicator light
Configuration: Handheld IC66 * HHM500 or Proficy ME software remote configuration
Compatibility: GE 90-30/70/90 series PLC, ABB DCS, third-party equipment
IC660BBD022
There are no reviews yet.