GE IC660BBD022｜Genius I/O｜

1、 Channel configuration
Quantity: 16 independent I/O channels, 16 points per group
Mode: Each channel software can choose input (Sink) or output (Source)
Wiring: Source type, common terminal connected to 24VDC+

2、 Digital input
Rated voltage: 24VDC (18-30VDC)
Input impedance: ≥ 10k Ω
Response time: 1.7ms (basic)+software filtering (5/10/20/50/100ms)
High level: ≥ 15VDC; Low level: ≤ 5VDC
Diagnosis: Open circuit, short circuit, overheating, switch fault detection

3、 Digital output
Output type: MOSFET source type, high side switch
Rated voltage: 24VDC (18-30VDC)
Each current: 2A (continuous), surge 10A/10ms
Total output current: 16A (16 channels at full load simultaneously)
On delay: ≤ 1ms; Off delay: ≤ 2ms
Pressure drop: ≤ 2.0V@2A
Leakage current: ≤ 1mA (off state)
Minimum load: 50mA (No Load function needs to be enabled when there is no load)
Maximum switching frequency: 1Hz (in high wave scenarios)

4、 Electrical and Isolation
Working voltage: 18-30VDC (nominal 24VDC), ripple ≤ 10%
Isolation strength: 1500VAC/1 minute (between modules, channel to ground)
Power consumption: typical 150mA, maximum 300mA (24VDC); Full load 68.8W
Power off hold: 10ms (data not lost in case of power interruption)

5、 Environment and Physics
Working temperature: 0 ° C~+60 ° C
Storage temperature: -40 ° C~+100 ° C
Relative humidity: 5% -95% RH (without condensation)
Vibration: 5-10Hz: 5.08mm displacement; 10–200Hz：1G
Impact: 30g (11ms)
Dimensions (mm): 229 (length) x 76 (width) x 102 (height)
Weight: Approximately 1.4 kg
Installation: 35mm DIN rail or panel installation
Protection: IP20

6、 Communication and Diagnosis
Bus protocol: Genius Bus
Topology: daisy chain, up to 32 nodes, up to 2km away
Diagnostic LED: module OK, I/O enabled, each channel status indicator light
Configuration: Handheld IC66 * HHM500 or Proficy ME software remote configuration
Compatibility: GE 90-30/70/90 series PLC, ABB DCS, third-party equipment

IC660BBD022

GE IC660BBD022｜Genius I/O｜