Our company specializes in importing industrial control spare parts, and we can help you transfer most of them from abroad. Due to the wide variety of models, we were unable to upload physical pictures one by one!
If the model you need cannot be found in our store, please feel free to inquire at any time.
GE DS200LDCCH1AGA｜Control Board｜
Processor and Memory
Main processor: 16 bit dedicated industrial MCU, 20MHz
On chip processors: 4 (LAN control LCP, driver control DCP, communication MCP, fault diagnosis FCP)
Program storage: 64KB EPROM (system firmware)
Configuration storage: 16KB EEPROM (user parameters)
Operating memory: 8KB RAM (data cache)
Electrical specifications
Backboard power supply:+5V DC (system bus)
Auxiliary power supply: 24V DC (LVDT excitation/IO)
Power consumption: approximately 20W
Communication bus:
Mark V Backplane: 10Mbps (Private Protocol)
RS-485: Modbus RTU (diagnostic/configuration)
RS-232: 9600bps, 8N1 (local debugging)
Digital IO and Interface
Digital input DI: 32 channels (dry contact/24V level)
Digital output DO: 16 channels (relay/solid-state)
LVDT interface: 4 channels (position feedback)
Jumper configuration: 14 (address/mode settings)
Environment and Physics
Working temperature: -30 ° C~+70 ° C (non condensing)
Storage temperature: -40 ° C~+85 ° C
Humidity: 5% -95% (non condensing)
Size: 175 × 120 × 35 mm (standard single slot VME)
Weight: Approximately 0.43kg (2lbs)
Protection level: IP20 (cabinet installation)
Application scenarios
Excitation control: GE EX2000 excitation system (generator excitation regulation)
Drive control: DC2000 DC driver (turbine/compressor speed regulation)
Turbine control: Mark V gas/turbine system (speed/load control)
Data communication: LAN interconnection within the system, remote diagnostic interface
DS200LDCCH1AGA
There are no reviews yet.